Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Schofield, WI

Martin Door Torsion Spring Replacement in Schofield, WI

Torsion springs replaced and wound correctly, with high-cycle upgrades available. Typical cost $200-$450.

Need Martin Door torsion spring replacement in Schofield, WI? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Torsion springs replaced and wound correctly, with high-cycle upgrades available. Whether your Martin Door garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for Martin Door torsion spring replacement?

  • A gap in the spring mounted on the bar above the door
  • The door slams shut or won't stay open
  • Only one side of the door lifts and the door goes crooked
  • The door is suddenly too heavy to lift by hand

Common causes

  • Normal fatigue at the end of the spring's rated cycles
  • Rust or lack of lubrication
  • An undersized spring working too hard
  • A door that's been made heavier with insulation or new panels

What you can check yourself

  • Count the springs above the door. Two-spring doors should have both replaced together.
  • Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
  • Note how often the door is used each day so the right cycle rating can be chosen.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Clamp the door and unwind the old springs with proper winding bars
  2. Measure wire size, inside diameter and length, and weigh the door
  3. Install correctly rated springs, upgrading to high-cycle if you use the door a lot
  4. Wind to the right number of turns and set the door's balance
  5. Lubricate, adjust the cables and test the full travel

Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.

Typical Martin Door torsion spring replacement prices

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Martin Door services

Serving Schofield, WI and nearby towns

In Wisconsin, spring failures spike during cold snaps, when worn steel is at its most brittle. If your springs are near the end of their cycle life, replacing them before winter is cheaper than an emergency call on the coldest morning of the year.

Technicians serve all of Schofield (ZIP code 54476), plus Rothschild (1.7 mi), Weston (3.1 mi), Rib Mountain (3.5 mi) and Wausau (3.6 mi). Call (833) 435-8883 to book a visit in Schofield.

Martin Door Torsion Spring Replacement: frequently asked questions

How much does Martin Door torsion spring replacement cost in Schofield, WI?

Martin Door Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Martin Door torsion spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Martin Door torsion spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Martin Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Wisconsin or Schofield requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Schofield, WI

Hörmann Garage Door Track Repair

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$400

Clopay Garage Door Repair

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$450

Overhead Door Garage Door Cable Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$350

Overhead Door Extension Spring Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$350

Trac-Rite Roll-Up Door Repair

Trac-Rite roll-up doors are widely used in self-storage buildings.

Typical $150-$600

Insulated Garage Door Installation

Polystyrene and polyurethane insulated doors that cut noise and temperature swings.

Typical $1,500-$5,000

Moore-O-Matic Remote & Keypad Programming

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $50-$150

Raynor Garage Door Opener Repair

Openers that hum, click, reverse or won't respond, diagnosed and repaired.

Typical $125-$350

Amarr Garage Door Roller Replacement

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$350

Sommer Garage Door Opener Installation

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $350-$800

Haas Door Weather Seal Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $100-$300

Raynor Garage Door Track Repair

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $150-$400

Garage door stuck, noisy or broken?

Talk to a garage door technician in Schofield, WI now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote